How to Coat a Garage Floor With Epoxy?

Looking to give your garage floor one last polish? Every time you step into your garage to get into your automobile, a bright, shining epoxy floor coating will make you and your automobile feel like you're entering a showroom. Epoxy garage flooring is a worthwhile investment since it not only completes the professional appearance but also repels beads water, oil stains, and wipes clean like a kitchen counter. Here’s how to epoxy your garage floor using 4 steps.

Step 1: Prepare and wash the garage flooring

Placing plastic sheeting on the walls along the foundation's edge or at the altitude where the epoxy will be applied up the walls requires the use of painter's tape. To get rid of dust and debris, properly sweep the floor. Dust all the seams and nooks with an old brush.

Step 2: Prepare the epoxy paint

Pour the hardener into the epoxy paint and start stirring. Ensure that you thoroughly scrape the hardener into the paint. The two ingredients should be thoroughly combined after three minutes of careful stirring.

Step 3: Roll it out

Find the corner that is furthest away from the exit. Paint a 10-by-10-foot area with epoxy paint using a 3/8-inch-nap roller with an extended handle. When compared to standard house paint, epoxy must feel slightly thick and greasy. Rewet the roller, then pass it over the section perpendicularly while feathering out the wavy lines once again.

Step 4: Apply the colour flakes

After each section of the topcoat of paint, pause to add the colour flakes if the surface is still wet.

Spread the flakes evenly over the area by softly dusting them at first, then gradually increasing the density until you achieve the desired coating of epoxy flooring in Brighton.

The aforementioned 4 steps are very important to successfully coat a garage floor using epoxy. Share this blog with your friends if you find it helpful!